xilanh điện compact DRS2 series

Ideal for fine feed and high accuracy positioning

Structure with integrated stepping motor and ball screw

Two kinds of drive screws, a grinding ball screw and a rolled ball screw

High load capacity and high speed (mounting angle dimension 42 mm with guide type)

Shorter time to device startup

Aggregate linear motion mechanism in compact body

·

Since the parts that we had made before are unnecessary, we can shorten the time for device design and component selection.

·

It reduces the time required for assembly and adjustment of mounting accuracy, leading to higher production efficiency.

Required parameters set during operation

<Minimum movement amount>

Built-in positioning function type

: 0.001 mm

Pulse train input type

: 0.001 mm

Moving amount can be set in units of "mm" (MEXE 02)

Comparison of the number of components

<Example of configuration when moving a work by the same stroke length>

Space saving and wiring reduction with ABZO sensor

In addition to compact and lightweight equipment with compact body, since the ABZO sensor is mounted, origin sensor is unnecessary. 
In addition to contributing to space saving and wiring reduction of additional equipment, periodic maintenance and troubles when using the origin sensor can be avoided.

Fulfilling pushing function

Pushing force and time can be freely changed

After completion of positioning operation, the DRS 2 series can easily shift to pushing operation. You can also change the pressing force and time freely.

·

Since the pressing force and pressing time can be set for each operation data No., you can easily change the data No. by selecting it.

·

It is possible to use properly at the stage of dropping the force so that the position does not shift, slowly press-fitting it, and pushing it up in a short time.

Pushing motion viewed with motion pictures

Pushable at low speed

Approach work at high speed. You can decelerate immediately before hits and push at low speed.

·

Since impact is hardly generated at the time of pressing, cushion mechanism for absorbing shock is unnecessary.

·

Since it can approach at a high speed until just before pressing, it will shorten the tact time of the equipment.

Pulse train input type can also be pressed

By setting the T - MODE input, it is also possible to perform pushing operation without generating an overload alarm for pulse train input type. 
It is convenient when pulse train control is performed and pushing operation is required.